DOC 6511_Release K
ATS-6511A/B/C Users Guide
22
Users can export the file using the --export option, download it via FTP, and edit the file in an
editor of their choice. A Linux editor is recommended to prevent the Carriage Returns/Linefeeds
from becoming and issue. Once the file has been edited users can upload the new file and then
use the --import option to bring in the new file. Once successfully imported the system will load
and begin using the imported file. See Appendix D for the detailed command information.
To check the status of this feature use the settings syscfg command.
ATS-6511>settings syscfg
[mode] system
[OK] 2013-09-05T23:51:48Z
If configuration errors are detected the system will light the front panel alarm light and the alarms
command will provide an indication of the error.
ATS-6511>alarm
[alarm] syscfg -- Incorrect format in slot 6 port 2: expected=B, actual=H
[OK] 2013-09-05T23:54:07Z
ATS-6511>alarms
[syscfg]
[occurrences] 1
[set]
[what] Incorrect format in slot 6 port 2: expected=B, actual=H
[when] 2013-09-05-23:53:16.800
[OK] 2013-09-05T23:55:35Z
To get a complete list of the configuration errors use the status syscfg:errors command.
ATS-6511>status syscfg:errors
[1] Incorrect format in slot 6 port 2: expected=B, actual=H
[2] Incorrect signal word in slot 6 port 2: expected=120, actual=121
[OK] 2013-09-05T23:56:38Z
To stop using this feature use:
ATS-6511>syscfg --mode standalone
Set Mode
[OK] 2013-09-05T23:53:17Z
Once the system has been set up for the correct mode use the save command to save the current
system settings and the system will use these settings after a power cycle, restart, or reboot.