DOC 6511_Release K
ATS-6511A/B/C Users Guide
38
[fiber_signal_present]
[active] false
[cleared]
[what] Fiber signal is present
[when] 2011-06-09-21:26:38.331
[occurrences] 1
[set]
[what] Fiber signal is missing Typical at start up.
[when] 1998-01-01-00:02:31.457
[firmware_version_mismatch]
[active] false
[occurrences] 0
[hardware_internal]
[active] false
[occurrences] 0
[holdover_ref_comm_error]
[active] false
[occurrences] 0
[holdover_ref_missing]
[active] false
[occurrences] 0
[holdover_ref_unlocked]
[active] false
[occurrences] 0
[hp5071]
[electron_multiplier_voltage]
[active] false
[occurrences] 0
[locked]
[active] false
[occurrences] 0
[oscillator_control]
[active] false
[occurrences] 0
[signal_gain]
[active] false
[occurrences] 0
[leapseconds]
[internal_error]
[active] false
[occurrences] 0
[ocxo_freq_control]
[active] false
[occurrences] 0
H. Each [output modules] [1-6] should have zero active errors and the [outputs disabled] and
[outputs unlocked] active blocks should be zero. The [power supply] [0-1] active blocks
should also be zero.
[output_modules]
[1]
[active] false
[occurrences] 0
[2]
[active] false
[occurrences] 0
[3]
[active] false If a card is not installed in a slot that slot # will not be present
To Next Page
Loading...
Need help?
General
