Synapse SE72 - Advanced Programming and Features; Programming Automatic Schedules

SYN-INT-E01 11
From this mode, the screen displays the temperature, the
set point, the hour, the day of the week and the current pro-
grammed period number (1 to 4; as applicable).
Programming Procedure of the Automatic Mode
After programming a day of the week, you can copy this setting;
see “Copy of the Programming”.
1.To access theProgrammingmode,press down the dayof
the week button that you want to program (Mon to Sun).
Onceyoureleasethebutton,theselecteddayoftheweek
isdisplayed,theSETiconblinks and theperiodnumber 1
blinkstoo.
2.Selecttheperiodbutton(1to4)thatyouwanttoprogram
usingthe+or–button.Foreachperiod,thehourandtheset
pointaredisplayed.Thehourdisplays–-:-–andthesetpoint
displays––ifthereisnoprogrammingfortheperiod.You
mustconrmtheperiodbypressingdowntheModebutton.
3.Thetwoguresrepresentingthehourblinktoindicatethat
youcanadjustthem(from00to23)usingthe+or–button.
YoumustconrmtheadjustmentbypressingdowntheMode
button.
4.After conrmation, the gures representing the minutes
(thelast2gures)blink.Youcanadjustandconrmthemin
themannerdescribedinpoint3.Notethattheminutescan
onlybeadjustedbyincrementsof15minutes.
5.Theperiodsetpointblinksandyoucanadjustitusingthe
+or–button.Youmustconrmtheadjustmentbypressing
downtheModebutton.
6.Aftersetpointconrmation,theprogrammingiscompleted.
The following period number blinks. For example, if the
previously programmed periodwas 1,period 2blinks.It is
thenpossibletocontinuetheprogrammingofthisperiodby
pressingdowntheModebutton.Youcanalsoselectanother
periodusingthe+or–button.
7.Attheendofperiod4programming,youautomaticallyexit
theProgrammingmode.