Synapse SE72 - Anticipated Start and Program Copying

To Next Page

To Previous Page

SYN-INT-E0112

At any time, you can exit the programming mode using one

of these 3 methods:

1-Pressdownthebuttonofthedayyouareadjusting.

2-Pressdownthebuttonofanotherdaytoprogramit.

3-PressdowntheExitbutton.

Moreover, if you do not press down any button for more than

1 minute, the thermostat will exit the Programming mode. In all

cases, the programming is saved.

Anticipated Start

This mode enables the room to reach the selected tempera-

ture at the programmed hour by starting or stopping the heat-

ing before this time. In fact, the thermostat estimates the delay

required to reach the set point of the next period at the pro-

grammed hour. This delay is obtained by the observation of the

temperature variations in the room and the results obtained dur-

ing the preceding anticipated starts. Therefore, results should

be increasingly precise day after day. From this mode, the ther-

mostat displays at any time the set point (SET) of the current pe-

riod. The “anticipated start” icon will blink when the anticipated

start of the next period begins.

For example, if the requested temperature between 8h00 am

and 10h00 pm is 22°C and between 10h00 pm and 8h00 am is

18°C, the set point (SET) will indicate 18°C until 7h59 am and

will switch to 22°C at 8h00 am. Thus, you will not see the pro-

gression carried out by the anticipated start, only the desired

result.

To activate or deactivate the anticipated start, the thermostat

must be in Auto or Pre Prog mode. Then, you must press down

the MODE button for at least 5 seconds. The anticipated start

icon (

) is displayed or hidden to indicate the activation or the

deactivation of the mode. This modication will apply to the

Auto as well as the Pre Prog mode. If you modify the tempera-

ture set point manually when these modes are activated, the an-

ticipated start of the next period will be cancelled.

N.B.

Please note that the anticipated start is initially activated when

you enter the Automatic or Preprogrammed mode. Thus, you

must deactivate it following the above procedure if needed.