Synapse SE72 - Preprogrammed Schedules and Selection; Viewing and Erasing Programs

SYN-INT-E0114
Erasing of the Programming
You must proceed as follows to erase a programming period.
1.Access the Programming mode as described previously
by pressing down the button corresponding to the day to
modify.Selecttheperiodtoeraseusingthe+or–button.
2.YoudonothavetopressdowntheModebuttontoconrm
the selection. However, doing so will not impact on the
erasing.
3.Simultaneouslypress down the + and – buttons to erase
theperiodprogramming.Thehourdisplays–-:-–andtheset
pointdisplays––toindicatethattheprogrammingiserased.
4.The erased period number blinks and you can select
anotherperiodtobeerasedorexittheProgrammingmode
followingoneofthe3methodsdescribedabove.
Preprogrammed Mode
The Preprogrammed mode allows an automatic programming
of the thermostat. 252 preprogrammings have been dened for
Ambient mode and 252, for Floor mode (A0 to Z1 and 0 to 9;
see appendix 1 to consult the corresponding tables). This mode
gives you the possibility to quickly program the thermostat us-
ing preprogrammings commonly used without having to do it
manually.
As from the Automatic mode, it is possible, at any time, to man-
ually adjust the set point. This set point will be effective until the
next set point change anticipated by the preprogramming. Note
that if the set point is lowered to OF, the programming will not
be effective.
From this mode, the screen displays the Ambient/Floor temper-
ature, the Ambient/Floor set point, the hour, the day of the week
and the letter and current number of the preprogramming
(A0 to Z1 and 0 to 9; alpha-numeric segment displayed on the
right-hand side of the hour; see appendix 1, p. 23).