Synapse SE72 - Safety, Controls, and Troubleshooting; Ambient;Floor Mode Switching

SYN-INT-E0116
View of the Preprogramming
The view of the selected preprogramming is made in a way sim-
ilar to the Auto mode programming. However, it is impossible to
modify the preprogramming.
You must proceed as follows:
1.Pressdownthe button corresponding totheday toview
(buttonsMontoSun).Whentheselecteddayisdisplayed,
theSETiconandperiodnumberblink.
2.Choosetheperiodnumber(1to2)toviewusingthe+or-
button.Foreachperiod,thehourandsetpointaredisplayed.
YoucanalsopressdowntheModebuttontoswitchtoperiod
2. If you press down the Mode button when period 2 is
displayed,youexittheViewmode.
At any time, you can exit the View mode using one of these
3 methods.
1-Pressdownthebuttonofthedayyouareviewing.
2-Pressdownanotherdaytoviewit.
3-PressdowntheExitbutton.
If you do not press down any button during 1 minute, the ther-
mostat quits the view mode. At any time, it is possible to change
the day to be viewed by pressing down the desired day button.
Ambient/Floor Mode
To switch from the Ambient mode to the Floor mode, or con-
versely, press down the A/F button (when you are not in any ad-
justment mode). Then, the temperature set point will become
the same as the Floor or Ambient mode temperature, as appli-
cable. However, if a set point is programmed for the current pe-
riod, it will take this value.