Synapse SE72 - Copy of the Programming; To Copy the Programming Day by Day; To Copy the Programming in Block

SYN-INT-E01 13
Copy of the Programming
You can apply the programming of one day of the week to oth-
er days by copying the programming day by day or in block.
To copy the programming day by day, you must:
1.Pressdownthesourcedaybutton(daytobecopied).
2.Hold down this button and press down the destination
daysonebyone.Thescreendisplaystheselecteddays.If
anerroroccurswhenyouarechoosingaday,pressdownthe
erroneousdayagaintocanceltheselection.
3.Afterallselectionsarecompleted,releasethesourceday
button.Theselected dayshavethesameprogrammingas
thesourceday.
To copy the programming in block, you must:
1.Pressdownthesourcedaybutton,holditandpressdown
thelastdayoftheblockyouwanttocopy.
2.Hold down these two buttons for 3 seconds. After this
time,thedaysoftheblockaredisplayedindicatingthatthe
copyinblockisactivated.
3.Release the buttons. The days of the block are not
displayedanymoreandthecurrentdayisdisplayed.
N.B. The block order is always increasing. For example, if the
source day is Thursday and the destination day is Monday, the
copy will only include Friday, Saturday, Sunday and Monday.