Synapse SE72 - Display in Degrees Celsius;Fahrenheit

SYN-INT-E01 9
them using the + or - button and conrm your choice by
pressingdowntheModeorDay/Hrbutton.
4.Thetwoguresindicatingtheminutesblink.Youmustadjust
them using the + or – button and conrm your choice by
pressingdowntheModeorDay/Hrbutton.Theadjustment
isthencompletedandthethermostatreturnstotheprevious
mode.
N.B.
At any time, you can exit the adjustment mode of the day and
the hour by pressing down the Exit button or by not pressing
any button during 1 minute.
In case of a power failure, the thermostat is self-sufcient for 2
hours. If the failure lasts less than 2 hours, the thermostat saves
the adjustment of the hour and the day of the week. When the
power is restored after an extensive failure (more than 2 hours),
the hour and the day of the week are recovered, but you must
update them.
Display in Degrees Celsius/Fahrenheit
The thermostat can display the ambient temperature and the set
point in degrees Celsius (standard factory setting) or Fahrenheit.
Adjustment procedure for degrees Celsius/Fahrenheit display.
1.ToswitchfromthedegreesCelsiustothedegreesFahrenheit,
and conversely, simultaneously press down the + and -
buttonsformorethan3secondsuntiltheSETiconblinks.
2.Pressdownthe+buttontoswitchfromthedegreesCelsius
to the degrees Fahrenheit, and conversely. The degree
CelsiusorFahrenheitsymbolisdisplayed.
3.When the adjustment is completed, press down the Exit
buttonordonotpressdownanybuttonduring5secondsto
exittheadjustmentfunction.
N.B.
This adjustment can be done from any of the three principal
modes.