Synapse SE72 - Temperature Set Point Adjustment; Time, Day, and Unit Settings

SYN-INT-E018
Temperature Set Points
The gures displayed beside the word “SET” indicate the ambi-
ent or the oor temperature set points. They can be displayed in
degrees Celsius or Fahrenheit (see “Display in degrees Celsius/
Fahrenheit”).
Out of any adjustment mode, press down the + button to in-
crease the set point, or the – button to decrease it. Set points
can only be adjusted by increments of 1 degree. To quickly scroll
through the set point values, press and hold down the button.
Maximum Floor Temperature Limitation
At any time, the oor temperature (in Floor mode) is maintained
at less than 28°C (82°F) in order to avoid overheating caused by
an excessive heating request, which could damage some ma-
terials or be detrimental for health. It is however possible to in-
crease this limit to 35°C (95°F). To do so, you must press down
the A/F button for at least 20 seconds. After 20 seconds, the
new maximum temperature will be displayed in replacement of
the Floor mode set point and will blink during 5 seconds. Then,
you can release the A/F button. To return to a maximum temper-
ature of 28°C, you must repeat the operation. Regardless of the
maximum oor set point (Floor mode), the maximum Ambient
mode set point will always be 35°C.
Adjustment of the Hour and the Day of the Week
Adjustment procedure of the hour and the day of the week.
1.PressdowntheDay/Hrbutton,whetheritisinMan,Autoor
PreProgmode.
2.At this moment, the SET icon and the day of the week
blinksandyoucanadjustthedayoftheweekusingthe
+or-buttonandconrmyourchoicebypressingdown
theModeorDay/Hrbutton.Youcanalsopressdownthe
desired day of the week button without using the + or -
button and conrm your choice using the Mode or Day/
Hrbutton.
3.The two gures indicating the hour blink. You must adjust