SYN-INT-E01 15
Choice of the Preprogramming
You can only access the Preprogramming mode when the ther-
mostat is out of any programming or adjustment function. Make
sure to choose the preprogrammings corresponding to the right
mode (Ambient /Floor, according to the attached tables).
You must proceed as follows to access the Preprogramming
mode:
1.PressdownthePreProgbutton.
2.ThePreProgiconandsavedselectedpreprogrammingare
displayed.This preprogramming canrange between 0 and
Z1.
3.From the Pre Prog mode, you can choose the rst 10
preprogrammings by pressing and releasing the Pre
Prog button. Each time you press down the button, the
preprogrammingswitches(from0to9).
4.Tochooseadvancedpreprogrammings,(seeappendix1),
pressdownthePreProgbuttonduring5seconds.Theletter
indicatorblinksandyoucanadjustitbypressingdownthe+
or–button.Oncetheletterischosen,youmustvalidateyour
choicebypressingdowntheModebutton.Theletterceases
toblinkandthegurestartstoblink.Thechoiceofthegure
ismadeinthesamewayasthatoftheletter(usingthe+or–
button).Oncethegureisselected,youmustvalidateyour
choicebypressingdowntheModebutton.
N.B.
If you do not press down any button for more than one minute
or press the Exit button, the thermostat exits the adjustment
function and saves the current choice. Then, the icons cease
to blink and the letter and the gure corresponding to the
selected preprogramming blink alternately until you select
another preprogramming. If the Pre Prog mode is activated
and you successively press down the Pre Prog button, the
preprogramming comes back to 0 and increases normally, as
described above.
To Next Page
Loading...