- 22 -
A.2 Diagnostics Mode
A.2.1 Guidelines and procedures for Diagnostics Mode:
Use the following step to go through the options within the Diagnostics Mode of the terminal:
Step 1. Enter the supervisor badge number and press [ENTER].
Step 2. From the menu that appears select (2) Diag (or Diagnostics if no finger reader is installed).
Step 3. Complete the testing for each group you want to diagnose, pressing the [ENTER] key to go onto the next test
item or using the [BACKSPACE] key to the previous test item:
a.
Mag or Prox
– stands for Magnetic or Proximity Reader
• For Terminals that are equipped with a Magnetic or Proximity reader, if you swipe the badge or
bring the badge to the terminal it will display the number of the badge on the screen.
b.
BC
– stand for Bar Code Reader
• For Terminals that are equipped with a Bar Code reader. The Screen displays 4 options for the type
of badge you are using, select the badge type by pressing it’s corresponding number associated
with your badge type.
• If you swipe the badge it will display the number of the badge on the screen.
c.
Select Relay 1-2
– for testing of the terminals two relay ports.
• For testing equipment connected to the terminals relays.
• Press the corresponding number associated with the relay you have connected to the terminal and
it will cause that relay to engage.
d.
Select Led#: 1-6
– this feature is not used
• This feature is not used, you can press the [ENTER] key to bypass the option.
e.
Select Sensor 1-4
– this feature is not used.
• This feature is not used, you can press the [ENTER] key to bypass this option.
f.
Keypad
– used for testing the keys on the keypad
• Press the keys on the keypad and they will display to the screen.
Step 4. Press [ENTER] to exit out from the last Diagnostics menu selection.
Appendix – B
Proximity Setup
B.1 Setting up the Proximity Reader
The proximity reader has the opportunity to read the badges several different ways depending on the badge type.
Use the following steps to setup the clock to identify the badge.
Step 1. Press the <F2> key and the <F5> keys simultaneously 6 times.
Step 2.
Step 3.
You will see on the screen “Wiegand Setup Bring Badge”
Place the badge next to the clock as you would to clock in.
The clock will beep and on the screen will display the badge number it is reading.
If you want to use that number, press [ENTER] and the clock will always read those badges
with that number.
o NOTE: The number showing may have a facility code (3 digit for 26-Bit badges, but may be
longer depending on badge) in front of the badge number you are looking for.
If you don’t see the number your looking for, bring the badge to the terminal again, and if
possible the terminal will display an alternative badge number.
o Repeat this process until you see the correct number.
If the clock can not read the badge as another number is will go back to the Time and Date on
the screen.
To Next Page
