Synesso MVP Hydra Basic Operation

Hopefully this step by step tour gives you the foundation you need to use the MVP Hydra to
your desired end.
On the following pages you will find:
 A description of the new timer
 Our graphic Quick Start Guide for ongoing reference and training
 A list of updates to the Hand Held Controller (in comparison to the most recent
Hydra)
THE TIMER:
1) There is a numeric counter that starts and stops with brew function, in a new one piece housing!
2) The bottom left corner shows which brew mode is currently selected. M (fully Manual), MP (Manual
Program) or VP (Volumetric Program)
3) The four column Brew Graph at the bottom center shows the 4 stages of brew function- Pre Infusion,
Ramp Up, Pump Pressure, and Ramp Down.
4) The dots that frame the counter show enabled programs ( 6 available) *note that program lights are
disabled in M mode, unless you are saving the last shot brewed
5) There is a disk icon that comes up in the bottom right corner when you hold right to enter save mode.
An arrow pointing left shows that you shift the brew handle left to save to the displayed position
6) A red triangle flashes in the center when flow of water is blocked, or if Save Mode is locked, or if the
Low Level probe in the steam tank is dry
1
2
3
4
5
6

Synesso MVP Hydra Specifications

General

Pump Type	Rotary
PID Temperature Control	Yes
Pre-infusion	Yes
Volumetric Dosing	Yes
Boiler Material	Stainless Steel
Pressure Profiling	Yes
Material	Stainless Steel
Water Reservoir	Direct plumb only