12
Chapter 2: Hardware Setup
To remove the RAM Module:
1
Follow step 1 to 3 of the "To install the RAM module" section to shut down your Network Video Recorder,
disconnect the cables, and then remove the bottom panel.
2
Push the levers on both sides of the memory module outwards. The module will be released from the slot.
3
Hold the memory module by its notches and remove it from the slot.
4
Replace the bottom panel. Replace and tighten the screws removed in step 1.
5
Reconnect the cables removed in step 1. Now, you may turn on your Network Video Recorder.
To Next Page
Loading...
