13
Chapter 2: Hardware Setup
Replace System Fan
Your Network Video Recorder will beep if the system fan is not working. Follow the steps below to replace the
malfunctioning fan with a good one.
To replace the system fan:
1
Shut down your Network Video Recorder and disconnect all connected cables to prevent any possible
damages.
2
Remove the 4 screws that secure the fan panel.
3
Remove the malfunctioning fan:
a
Pull the fan panel from your Network Video Recorder.
b
Disconnect the fan cable from the connector located near the bottom of the fan socket, and then remove the
fan panel.
To Next Page
Loading...
