getting started
5
SYNRAD OEM v30 Operator’s Manual Version 2
Inventory
Contents description
Each item listed in Table 1-1 is described below.
SYNRAD Firestar OEM v30 Laser – for cutting, welding, drilling, and marking a wide variety of products
and materials.
SYNRAD CO
2
Lasers Manual CD – contains a Firestar v30 manual that provides setup, operation, and
maintenance information for your OEM v30 laser.
Quick Start Plug (except SA models) – connects to the v30’s Interface A (DB-9) connector. A built-in
jumper enables the v30 for initial start-up and testing.
Cooling Tubing (water-cooled only) – carries cooling water from the chiller to the laser and back. This
black polyethylene tubing is 1/2-inch O.D. by 30 feet and must be cut to length.
Mounting Bolts – Three each 1/4–20 × 5/8" UNC capscrews are provided for fastening the Firestar v30
laser to your mounting surface.
Spare Fuse – fast-blow 20 A fuse incorporated into the positive DC power cable protects the laser’s internal
circuitry. See Troubleshooting in the Maintenance/Troubleshooting chapter for replacement information.
Final Test Report (not shown) – contains data collected during the laser’s nal pre-shipment test.
To Next Page
Loading...
Need help?
General
