11
Freshman Series - Owner's Manual - Installation, Operation, and Service Instruction - Version 1.1 EN
Figure 2 | Removing Supply Fan(s)
5.4 Removing Supply Fan(s)
Remove SUPPLY FAN MOTOR as follows
1. Turn OFF electrical supply to the unit.
2. Open front service panels of unit using key provided.
3. Disconnect the wire harness running to the fan motor. (Fig. 2)
4. Remove fastening screws from either side of fan assembly
5. Pull fan assembly straight out of unit and clean dirt from fan blades and around
motor housing.
6. Replace fan assembly in track, push in fully and re-secure with fastening screws.
7. Reconnect wire harness to fan motor.
8. Close service panels and lock with key, turn electrical power ON, and test
operation of the unit.
should perform the following.
Supply Fan Assembly
Fastening Screws
FRONT
Fan Pan
Shock
Hazard
Rotating Blades could
cause severe injury.
Keep hands clear.
machine to stop before
servicing.
General Preventative Maintenance
To Next Page
Loading...
