TW20_NS20_EW20 Series Weighing Indicator Operation Manual REV:01
5.10 Accumulation
The scale can be set to accumulate manually by pressing key. Only the total counts will be saved in
memory.
Before operation scale should be stable and return to zero, accumulation available only when weight more than
20d
5.10.1 Manual Accumulation
1 Place the load on the platform,the weight display will be show the net weight.
2 Press key, when STABLE indicator on.
3 Total counts and weight will be displayed with beep sound .
4 Remove the weight from the pan.
5 When display get zero and stable then place the second weight.
6 Press key, when STABLE indicator on.
7 It can continue until the memory gets fully .
5.10.2 Auto Load Accumulation
To enable the auto-load accumulation ,please refer to parameters 2. ADVANCED
SETTINGS >7.ACCUMULATION MODE > AUTO-LOAD
1 Place the load on the platform,the weight display will be show the net weight.
2 When stable indicator on ,a "beep" sound will be heard,display shows the count and total weight.
3 Remove the item and the scale will return to zero;
4 When display get zero and stable then place the second weight.
5 It can continue until the memory gets fully .
To Next Page
Loading...
Need help?
General
