IHB++ Series Technical Manual
- 10 -
6. OPERATION
Initial Start-up
Warm-up time of 15 minutes stabilizes the measured values after switching on.
6.1 Power ON/OFF
Switch on the scale by pressing . The display is switched on and the self
test is started.
If you want to switch off press the key again.
6.2 Zero
Environmental conditions can lead to the balance exactly zero in spite of the
pan not taking any strain. However, you can set the display of your balance to
zero any time by pressing key and therefore ensure that the weighing starts
at zero.
6.3 Tare
The weight of any container can be tared by pressing button so that with
subsequent weighing the net weight of the object being weighed is always
displayed.
Load weight on the pan.
Press key. Zero is displayed, and tare is subtracted.
Remove weight from the platform. Tared weight is displayed. It can
set only one tare value. It can display with a minus value.
Press key. Zero is displayed, tare weight is cleared.
6.4 Weighing Unit
Press key in the weighing mode to change the
Weighing unit: g / ct / lb / oz / d / ozt / dwt / mom / tl.T / tlj / t / bt / n
To Next Page
Loading...
Need help?
General
