T Scale IHB++ -300 User Manual

IHB++ Series Technical Manual
- 15 -
8. CALIBRATION
 Turn on the scale.
 Press key during self checking, display will be show f 1 unt
 Press key until display will be show tech
 Note: Before enter the tech menu, press calibration switch, which is
locating below the scale
 Press and keys, display will be show p 1 lin
8.1 Linear Calibration li near
 Press key to enter calibration, display will be shown pi n
 Press and keys, display will be show kg or lb, press key
to select the calibration unit kilograms or pounds, press key ,display will be
show Load0.
 *Note: Ensure the pan is empty
 After stable and zero indicator on, display will be show Load1
 Place the first calibration mass weight on the pan.
 After stable and zero indicator on, display will be show Load 2
 Add again the second calibration mass weight on the pan.
 After stable and zero indicator on, display will be show Load 3
 Add again the third calibration mass weight on the pan.
 After stable and zero indicator on, display will be show Load 4
 Add again the fourth calibration mass weight on the pan, ( *Note: Calibration
mass weight should be full capacity of the scale)
 After stable and zero indicator on, display will be show load 0 Remove the
calibration mass weight from the pan
 *Note: Ensure the pan is empty
 After stable and zero indicator on, display will be show Load 4
 Place the calibration mass weight on the pan, ( *Note: Calibration mass
weight should be full capacity of the scale)
 After stable and zero indicator on, display will be show Load 3
 Remove the fourth calibration mass weight from the pan

T Scale IHB++ -300 Specifications

General

Brand	T Scale
Model	IHB++ -300
Category	Scales
Language	English