TA Instruments DMA 850 - Connecting Air Source to Chiller Panel; Gas Inlet Connection and Instrument Selection

Air Chiller System (ACS) and Chiller Panel Getting Started Guide for the DMA 850 Page 25
5 Use 8 mm tubing (supplied) to connect the Chiller Panel Gas IN to your air source. An additional 8 mm
fitting is provided with the Chiller Panel, if needed. Ensure that the Quarter-Turn Valve is in the OFF
position.
Figure 14
6 Combined DHR/DMA Air Chiller Panel only: Turn the instrument selection knob clockwise until the
knob arrow points to the DMA 850/Q800 label.
Figure 15 Instrument selection knob pointing to DMA850/Q800.
Inlet Pressure Regulator
Quarter-Turn Valve
Gas Inlet 8 mm