Discovery TGA™ Getting Started Guide Page 42
are found in the accessory kit. For now, leave the sample hang-down wire in its case.
Figure 24 Sample hang-down wire installation tool.
9 Position the hang-down wire case so that the wire’s double bend hook is at the top.
10 With the sample hang-down wire still in its case, insert the bottom of the wire into the sample hang-
down installation tool, as shown below. Then remove the installation tool and wire from the case.
Figure 25 Inserting sample hang-down wire into installation tool.
11 Remove the flat object covering the furnace opening and lower the furnace to its fully open position.
Double bend hook
Installation tool
To Next Page
Loading...
