Discovery TGA™ Getting Started Guide Page 53
Installing the Autosampler Tray
When you receive your TGA, the Autosampler tray is shipped in the accessory box, separate from the
instrument. After unpacking the instrument and installing the instrument completely (see instructions in
this chapter), you will be ready to run samples using the Autosampler.
1 Locate the open slot on the Autosampler tray.
Figure 42 Slot on Autosampler tray.
2 Locate the guide pin on the instrument Autosampler.
Figure 43 Guide pin on instrument Autosampler.
To Next Page
Loading...
Need help?
General
