5
TA-CMI
4
TA-CMI
Important information
Important information
Charging of batteries
Radio frequency communication
TA-CMI uses radio frequency to communicate wirelessly between the instrument and
sensor units. Always turn off radio communication when there is risk that
TA-CMI disturbs other vital electronic devices, i.e. near medical equipment
and implanted cardiac pacemakers, in health care facilities, aircrafts, blasting
areas, areas with potentially explosive atmosperes and other areas posted
“turn off two-way radio”! You turn off radio communication by setting the radio
channel to “OFF” in the Instrument setup menu (see page 30).
Storage recommendations
• Never leave water in the sensor unit when there is a risk of freezing (i.e. in a car during
winter)!
• Storage above 40°C reduces battery life.
Unpacking
Check that these items are delivered.
Unpacking
T
A
-C
M
I
D
o
k
n
r-0
1
/ 2
0
0
3
.0
6
G
B
M
a
n
u
a
l
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
........................
1
S
E
M
a
n
u
a
l
..........................................................
x
x
TA-CMI
1
2
3
4
5
6
7
8
9
10
11
12
1. Instrument unit
2. Sensor unit
3. Case
4. Connection cable
5. Temperature sensor Pt 1000
6. Charger Mascot 9725, 5.0 V
7. Measuring hose, 400 mm red with shut off valve
8. Measuring hose, 400 mm blue
9. Measuring needles
10. Chain for mounting
11. User Manual
12. Calibration certificate
5 hours!
Note! Both the sensor unit and the instrument unit contains batteries that need to be
charged. For best charging performance keep the connector clean. The supplied charger
from TA must be used!
Following batteries must be used (user not allowed to change batteries):
Instrument unit: 3 pcs NiMh type AA/R6
Sensor unit: 2 pcs NiMh type AAA/R03
Warning! Do not open the instrument as this could damage the warranty seal and void
your guarantee! See page 2 for further information.
!
To Next Page
Loading...
Need help?
General
