WWW.TACTACAM.COM
GETTING TO KNOW YOUR TACTACAM
POWERING ON AND RECORDING
1. Push the Rec/Power button. You will
feel the camera vibrate 2 times and see a
blinking green light coming from the
Rec/Power button. The green LED must
be blinking for the camera to be recording.
The process takes approximately 3 seconds.
NOTE: If light does not begin to ash,
make sure your SD Card is installed,
formatted, and not lled with videos.
2. To pause your recording quickly push
the Rec/Power button. The camera will
vibrate 1 time and the green light will go
solid.
3. With the camera paused, change the
camera’s modes by pushing the mode
button. (Excludes Solo)
4. To power your camera completely off
just push and hold the Rec/Power button
for 5 seconds.
5. The camera will automatically power
off to save battery when not recording
(left in pause mode) after 3 minutes.
To Next Page
Loading...
Need help?
General
