TB7300 Installation and Operation Manual Installation 61
© Tait International Limited December 2022
To copy configurations between base stations, you can download the
configuration file from the source base station, then upload and restore
this to a new base station.
Notice Before you restore the base station configuration, you must
put the base station ‘Offline’. If the base station is not offline, restore
does not work.
■ Restore a configuration: makes the selected configuration active
■ Download a configuration: copy the selected configuration to your
computer so that you can store it. To download a configuration file,
click on the name of the saved configuration in the list of saved
configurations.
■ Create a human readable configuration report: download and save a text
report of the base station’s configuration settings. You can use it to
capture, view, review, and compare configurations.
It is safe to restore configurations created under different base station
software versions than the one currently operating. When restoring a
configuration from an old version that does not contain values defined
for all configurations parameters, any absent data values are set to the
default.
The following parameters are not over-written when restoring a
configuration from a different base station:
■ Secure shell (SSH) console access enabled
■ Receiver number
■ Host name
■ Default channel
■ Operating mode
■ IP address
■ Subnet mask
■ Gateway address
■ Link speed
To Next Page
Loading...
Need help?
General
