Tait TB9400 - Page 45

TB9400 Specifications Manual Compliance Standards 45
© Tait Limited July 2017
RF and EMC
Compliances
The following table shows which variants of the TB9400 have been tested
and approved to the listed standards.
A tick indicates the compliance has been received, a date indicates when
the compliance is expected to be received, and a blank cell indicates there
are currently no plans to apply for this compliance.
B3 Band H Band K4 Band
50W 100W
Receive-
only 50W 100W
Receive
-only 50W 100W
Receive-
only
RF - P25 Phase 1
CFR Title 47 Parts 15 and 90 (FCC) ✓✓ ✓ ✓✓✓✓✓
CFR Title 47 Parts 22 and 74 (FCC) ✓✓––
a
––
a
P25 CAP (P25-CAB-CAI_TEST_REQ March 2010) ✓✓✓✓✓ ✓
RSS-119 (IC) ✓✓––
b
✓✓
__b
✓✓––
b
EN 300 113-1, EN 300 113-2 (ETSI) ✓✓ ✓ ✓✓✓
AS/NZS 4768 Appendix A ✓✓ ✓ ✓✓✓
ANATEL Resolution 554 ✓✓––
c
✓ ––
c
RF - P25 Phase 2
CFR Title 47 Parts 15 and 90 (FCC) ✓✓ ✓✓
__e
✓✓
CFR Title 47 Parts 22 and 74 (FCC) ✓✓
RSS-119 (IC) ✓✓ ✓✓ ✓✓
EN 300 113-1, EN 300 113-2 (ETSI) ✓✓ ✓✓
AS/NZS 4768 Appendix A ✓✓ ✓✓
ANATEL Resolution 554 ✓✓ ✓
RF - Analog
CFR Title 47 Parts 15 and 90 (FCC) ✓✓ ✓––
d
––
d
✓✓✓ ✓
EN 300 086-1, EN 300 086-2 (ETSI) ––
d
––
d
––
d
––
d
––
d
__d
AS/NZS 4295 Appendix B ––
d
––
d
––
d
––
d
––
d
__d
EMC
CFR Title 47 Part 15 (FCC) / RSS-Gen (IC) ✓✓ ✓ ✓✓✓✓✓ ✓
EN 301 489-1, EN 301 489-5 (ETSI) ✓✓ ✓ ✓✓✓
ANATEL Resolution 442 ✓✓––
c
✓ ––
c
a. Not applicable.
b. IC certification of the test report is not required for receive-only base stations. However, the IC labelling requirement must be complied with, as
described in Notice 2012-DRS0126 paragraph 2.2.2.1.
c. Not required for receive-only base stations.
d. Date to be confirmed.
e. Subject to Part 15 only.