TM8100/TM8200 Service Manual Description 55
© Tait Electronics Limited June 2006
2.6 Operation in Transmit Mode
Overview This section describes the functioning of the transceiver in transmit mode.
The operation of the transceiver is illustrated in Figure 2.16 on page 51.
These block diagrams show the hardware modules integrated with the
software modules:
■ hardware (transmitter, receiver, CODEC and audio)
■ RISC processor (on FPGA of digital board)
■ custom logic (on FPGA of digital board)
■ DSP block (on digital board).
The transmit path consists of three major functional parts:
■ audio processing and signalling
■ frequency synthesizer
■ RF transmitter.
To Next Page
Loading...
