M2259-00-200-812 Tait Orca Portable (TOP) Encryption 43
Copyright TEL Encrypted Radio Programming and Service Manual
Fit Flex to Orca PCB (top side)
1. Turn PCB over and bend flex carefully around PCB as shown
2. Bend flex at crease, then holding flex in place with tweezers, solder flex pads to the pads
vacated by C567
3. Solder flex to can, holding soldering iron to each point for at least three seconds to ensure
permanent join
4. Solder single flex pad indicated to IC512 pin 1
5. Solder flex pad to pad vacated by R4, as indicated
6. Solder single flex pad indicated to TP13
Note: Take care not to short adjacent components when soldering to TP13
1
6
4
2
3
5
To Next Page
Loading...
