M2259-00-200-812 Contents 5
Copyright TEL Encrypted Radio Programming and Service Manual
Contents
Section Title Page
1 Service Information 7
1.1 Servicing Accreditation 7
1.2 Tools Required 7
1.3 Warnings 7
1.4 Anti-Static Bench Set-Up 7
2Introduction 9
2.1 Encrypted Radio Programming and Service Kit 9
2.2 Related Documents 9
2.3 Encryption Module Compatibility 9
2.4 Radio Hardware Compatibility 10
2.5 Radio Firmware and Software Compatibility 10
2.6 Tait Encryption Products 10
3 System Operation 13
3.1 Configuration 13
3.2 Compatibility 13
3.3 Tait Encryption Interface Signal Specifications 14
4 Tait Orca Portable (TOP) Encryption 15
4.1 Circuit Operation 15
4.2 Programming the TOP Radio 17
4.3 Programming the Encryption Module 19
4.4 Testing the Encryption Module 20
4.5 TOP Encryption Upgrade Flex PCB Information 21
4.6 Encryption-Enabled TOP Operating Instructions 37
4.7 TOP Fault Finding 38
4.8 Fitting the TOP Encryption Upgrade Flex 39
5 T2000 Radio Encryption 47
5.1 Circuit Operation 47
5.2 Programming the T2000 radio 48
5.3 Programming the Encryption Module 48
5.4 Testing the Encryption Module 49
5.5 T2000 Encryption Flex PCB Information 51
5.6 Encryption-Enabled T2000 Operating Instructions 63
5.7 T2000 Fault Finding 64
5.8 Fitting the T2000 Encryption Upgrade Flex 65
6 Transcrypt Programming 69
6.1 OTAR Programming 69
6.2 Direct Programming 70
6.3 Operation 70
6.4 Using a TOP as an OTAR Programming Transmitter 70
6.5 Using a T2000 as an OTAR Programming Transmitter 71
6.6 Programming a Transcrypt Encryption Module 71
6.7 Security Codes 71
6.8 Programmer Configurations 72
6.9 Transcrypt Module Default Settings 72
6.10 Testing 72
6.11 Transcrypt OTAR Programming Cables 74