Tait TOP - Transcrypt OTAR Programming Cables

74 Transcrypt Programming M2259-00-200-812
Encrypted Radio Programming and Service Manual Copyright TEL
6.11 Transcrypt OTAR Programming Cables
The Tait Encrypted Radio Programming and Service Kit (IPN TOPA-EA-002) includes these
dedicated TOP programming cables:
 IPN 219-02841-00 - Top Encryption OTAR Programming Cable
 IPN 219-02128-00 - Top Encryption OTAR Programming Cable
One of these will connect the radio your system uses as a programming transmitter, to the
Transcrypt OTAR module. Only one of these cables is required - check which cable connects to
the accessory connector on the radio model you have, and discard the other cable.
For Direct Programming a TOP encrypted radio, you will require the following cable:
 TOPA-EA-008G - Top Encryption Direct Programming Cable. (See page 76)
6.11.1 TOP Encryption OTAR Programming Cables
Two TOP Programming Cables are included in the OTAR Service and Programming Kit. They
can connect a TOP programming transmitter radio (via the Accessory connector) to the
Transcrypt OTAR Programmer.
IPN 219-02841-00
Cable Signal Specification
.
Parts List
Signal TOP Signal Sense/Level TOP Wire TR30-306X
PTT PTT Active low pin 3 Violet pin 9
Ground GND pin 2 Black pin 11
Tx Out Mod-Audio (dc block in lead) 1V p-p pin 9 Blue pin 15
+13V8 (programmer requires power pack) - pin 1
Rx In Rx-Det-AF (dc block in lead) 0.5V p-p pin 8 Green pin 5
Qty IPN Description
1 OPA-AA-001 T/ORCA SPKR MIC PCB ASSY
1 303-20058-01 LOK AUX CONN T/ORCA
1 303-20061-00 LOK RING AUX CONN T/ORCA
1 308-01055-03 HSNG T/ORCA ACC CONN CLIP
1 345-00020-09 SCRW M2*5MM SS PAN TORX PATCH
1 354-01044-00 BUSH PSM SHK-B-M2-4.0 INS
9
1
5
1
1
5
530 mm
1
0
0
n
1
0
0
n
Grommet 6mm Cable
20mm
20mm