Tait TOP - Page 42

42 Tait Orca Portable (TOP) Encryption M2259-00-200-812
Encrypted Radio Programming and Service Manual Copyright TEL
Fit Flex to Orca PCB (bottom side)
1. Lay flex onto PCB exactly as shown
2. Fit flex firmly into PL1 flex edge connector and press locking tabs closed
3. Solder two flex pads to the position vacated by C572
4. Ensure flex fits exactly to corner of can, with the edge clear of the PA can tag
5. Solder flex to cans, holding soldering iron to each point for at least three seconds to
ensure permanent joins
6. Solder flex pad to top pin of LED1 as shown
7. Solder flex pads to space vacated by R356
8. Solder flex pads to volume control switch pins 2 and 3 as shown
1
4
5
2
3
7
6
8