EasyManua.ls Logo

Tait TP9100 Series P25 - Charger Information and Battery Handling

Tait TP9100 Series P25
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
130 Charging and caring for batteries
About the chargers
There are three types of charger available for your
Tait radio battery:
Desktop charger: Small enough to
fit on a desk, it charges one bat-
tery at a time.
In Brazil, portable radios are
only allowed to use the desktop charger.
Multicharger:
Charges up to six
batteries. It can be
mounted on a desk,
on a wall, or in an
equipment rack.
Warning The multi-charger must be connected to an
earthed mains socket-outlet.
Vehicle charger : Charges one bat-
tery at a time while installed in a
vehicle.
Notice Tait recommends that you use a
desktop charger or multicharger, not the
vehicle charger, to prime a nickel metal
hydride battery (see page 27). After a
battery is primed, the battery does not
require regular additional charging in a desktop
charger or multicharger.
Unless otherwise indicated, the charging advice and
instructions in this chapter apply to all chargers.
Special conditions when using
IS radios
Warning Fit only an IS-approved battery to an IS
radio. Fitting a battery or accessory that is not IS-
approved exposes the customer to a risk of explosion
which could cause serious injury or death.

Table of Contents

Related product manuals