Charging and caring for batteries 137
LED behavior
If there is a battery in the charger when power is
supplied to the charger, the LEDs behave as follows:
If the charger does not behave as expected:
■ Make sure the radio or battery is seated properly
in the charger.
■ Check that the charger is properly plugged in.
■ Check that the battery and charger contacts are
clean. To clean, wipe the contacts with a dry lint-
free cloth to remove any dirt, oil or grease.
LEDs Meaning
briefly
The charger has been connected to a
power supply
flashing
A NiMH battery is being primed.
If possible, do not interrupt until the green
LED is lit
steady
The battery is charging
steady
Charging complete. Remove the battery,
or leave it in the charger.
steady
The battery temperature is outside the
normal charging range. Charging will start
or resume once the temperature is within
normal limits. No action is required by you.
flashing
There is a fault. See "Troubleshooting the
charger" on page 147.
There is a fault. See "Troubleshooting the
charger" on page 147.
To Next Page
Loading...
