Table of contents
11-7. To read /Not to read Condition data (Condition data)..........................................................151
11-8. To display/Not to display the screen for reading Condition data
(Input confirmation of condition file)............................................................................... 152
11-9. To lower / raise presser foot (TMBR-SC only).....................................................................153
11-10. To move down/up the presser foot and needle bar before tracing ......................................154
Chapter 6 Functions concerning frame movement
1. To return the frame (Frame Back) / to advance the frame (Frame Forward) ...............................156
1-1. To switch Frame Back / Frame Forward..............................................................................156
1-2. To execute by Stop code, to specify number of stitches to execute....................................157
1-3. To specify the needle position (stitch number) and perform FB/FF
(Needle position specification FB/FF)............................................................................159
1-4. To perform frame forward using the USB key (USB button)................................................161
1-5. To change a frame feed amount of frame back / frame forward..........................................162
2. Necessary works after replacing the frame ..................................................................................163
2-1. Change of frame type, Rotation of design by 180°..............................................................163
3. To return the frame to the original position...................................................................................165
3-1. To return the moved frame to the previous position (Manual Offset) ................................. 165
3-2. To return moved frame to original position and start operation
(Return the frame after manual frame travel) .................................................................166
3-3. To prevent displacement of design when the power is shut off during operation
(Power resume) .............................................................................................................167
3-4. To memorize frame origin (Frame origin memory) ..............................................................168
3-5. To perform Frame origin memory when the power is turned ON
(Frame origin memory with the power-ON) ...................................................................169
4. To return the frame to the design start position............................................................................171
4-1. To return the frame to the design start position manually
(Return to the design start position)...............................................................................171
4-2. To return the frame to the design start position automatically (Auto Origin Return)............172
To Next Page
Loading...
