Table of contents
7-3. To divide a long stitch (Auto Jump)..................................................................................... 112
7-4. To change stitching condition in every needle bar (Setting in units of Needle bar)............. 113
7-5. To delete tiny stitch (Cleanup)............................................................................................. 117
7-6. To change thread tension (Frame Start Timing) ................................................................. 118
7-7. Not to stand out the edge of upper thread (Upper thread lock timing) ................................ 119
7-8. To embroider by using badly passing thread or loosely twisted thread (FS mode Lock) .... 120
7-9. To perform return stitches at start of sewing (Forced Return Stitches)............................... 121
8. To increase embroidering efficiency.............................................................................................122
8-1. To change number of lowering needle bar at slow operation (Main Shaft Inching) ............ 122
8-2. To set embroidery speed at slow operation (Inching r.p.m) ................................................ 123
8-3. To collect up frame moving amount of consecutive jump stitches
in a batch to feed the frame all at once (Jump code combination)................................ 124
8-4. To change moving speed of needle bar case (Color change speed)................................. 124
8-5. To change travel speed of the frame (Frame Travel Speed) .............................................. 125
8-6. To set data of the design automatically after the embroidery is finished
(Automatic Data Set after finishing embroidery)............................................................. 126
8-7. Embroidering multiple name designs (continuous names).................................................. 127
9. To edit design............................................................................................................................... 129
9-1. To modify the stitch (Data Edit "Modify")............................................................................. 129
9-2. To insert the stitch (Data Edit "Insert") ................................................................................ 132
9-3. To delete the stitch (Data Edit "Delete").............................................................................. 136
10. Setting and resetting of password................................................................................................ 139
10-1. To change password (Functional Limit of Password).......................................................... 139
10-2. To cancel the password ...................................................................................................... 141
10-3. Not to display some operation (Functional limit level)......................................................... 143
11. Various functions.......................................................................................................................... 145
11-1. To check the number of total stitches up to now (Total Stitch Counter).............................. 145
11-2. To color in every needle bar (Needle Bar Color)................................................................. 146
11-3. To display the setting color when making the design (Needle bar information).................. 147
11-4. To check version of current sdoftware (Software Version).................................................. 148
11-5. To switch display language (Language).............................................................................. 149
11-6. To release fixing of main shaft motor (Main shaft brake) .................................................... 150
To Next Page
Loading...
