Table of contents
Chapter 5 Functions concerning embroidery
1. To change color.............................................................................................................................. 74
1-1. To change color manually (Manual Color Change) ...............................................................74
1-2. To light the laser crosshair marker manually (Manual return to marker position).................. 76
2. To trim thread ................................................................................................................................. 77
2-1. To trim thread manually (Thread breakage indicator lamp)...................................................77
2-2. To trim thread manually (Manual Thread Trimming) ............................................................. 77
2-3. To trim thread automatically (ATH)........................................................................................ 78
2-4. To change thread breakage detecting sensitivity (Thread Detection) ................................... 81
2-5. To trim thread by the number of consecutive jump stitches (Jump Convert).........................83
2-6. To add thread trimming code to the design and trim thread (Data Edit "Insert") ...................84
2-7. To change thread trim timing (ATH Start Timing)..................................................................87
2-8. To set the sensitivity of ATH error detection (Sensitivity of ATH error detection) ................. 88
3. To set the embroidery speed.......................................................................................................... 90
3-1. To limit embroidery speed by stitch length (Min. Revolution) ................................................ 90
3-2. To set embroidery speed within speed limit section (Revolution limit) ..................................91
3-3. To decide upper limit value of the maximum speed (Max. Revolution Limit)........................92
4. To stop the machine ....................................................................................................................... 93
4-1. To stop the machine automatically when reaching the set value (Preset Halt) ....................93
4-2. To stop the machine before needle bar hits the frame (Software Frame Limit)....................94
4-3. To stop the machine with needle bar stuck in the material (Stop at Lower D.Point) ............. 96
4-4. To stop at Frame Limit (Frame Limit setting)......................................................................... 97
5. To change the direction and the size of the design ........................................................................99
5-1. To perform enlargement, rotation, reversion (Data Conversion) ........................................... 99
5-2. Tilt the design, change the placement (Design position adjustment) ..................................101
6. To embroider the same design repeatedly ...................................................................................105
6-1. To repeat to horizontal and vertical direction (Repeat)........................................................105
6-2. To repeat at the same place (A.S. after Auto Data Set) ......................................................108
7. To adjust finishing of embroidering...............................................................................................109
7-1. To adjust driving error of the frame (Backlash)...................................................................109
7-2. To adjust stitch length of satin stitch (Satin Stitch) ..............................................................110
To Next Page
Loading...
