Table of contents
Chapter 4 How to perform embroidery
1. To turn ON the power..................................................................................................................... 30
1-1. Power switch ......................................................................................................................... 30
1-2. To turn ON the power............................................................................................................31
2. Thread passing, fabric setting ........................................................................................................ 32
2-1. Thread passing...................................................................................................................... 32
2-2. To set fabric to embroidery frame ......................................................................................... 35
3. Registration of a design into the machine memory ........................................................................ 36
3-1. To use USB memory (Data Input USB)................................................................................. 36
3-2. To use personal computer (Data Input LAN)......................................................................... 40
3-3. To use personal computer (Data input "name") .................................................................... 45
4. Decision of an embroidery design and the color change sequence............................................... 47
4-1. To decide embroidery design (Data Setting)......................................................................... 47
4-2. To decide color change sequence (Needle Bar Selection) ................................................... 50
4-3. To change color automatically / to start operation automatically
(Auto Color Change "AC" / Auto Start "AS")..................................................................... 54
5. Decision of the design start position............................................................................................... 56
5-1. To check design size and setting contents of design (Check of design).............................. 56
5-2. To move frame to the design start position (Manual frame travel)........................................ 57
5-3. To check if design fits in embroidery space (Trace).............................................................. 60
6. Check items before embroidering .................................................................................................. 62
6-1. Maximum speed (Maximum RPM)........................................................................................ 62
6-2. Presser foot setting (TMBR-SC only).................................................................................... 63
7. Embroidery starts ........................................................................................................................... 66
7-1. Start and stop........................................................................................................................ 66
7-2. To return frame/To advance frame (Frame Back/Frame Forward) ....................................... 67
7-3. Handling of thread breakage................................................................................................. 70
7-4. Completion of embroidery ..................................................................................................... 72
To Next Page
Loading...
