56 Page
Examples
Controllers
Built-in controller Remote controller
1.
The display shows that PUMP TIMER 1 is in operation. The
current time falls within the time range that is set for for PUMP
TIMER 1.
Current time: 8:00 AM (8:00)
Set temperature of output water: 120 °F
PUMP TIMER 1: SET
PUMP TIMER 2: OFF
2.
The display shows that PUMP TIMER 1 is NOT in operation. The
current time falls outside the time range that is set for for PUMP
TIMER 1.
Current time: 10:00 AM (10:00)
Set temperature of output water: 120 °F
PUMP TIMER 1: SET
PUMP TIMER 2: OFF
3.
The display shows that PUMP TIMER 2 is in operation. The
current time falls within the time range that is set for for PUMP
TIMER 2.
Current time: 8:00 PM (20:00)
Set temperature of output water: 120 °F
PUMP TIMER 1: OFF
PUMP TIMER 2: SET
4.
The display shows that PUMP TIMER 2 is NOT in operation. The
current time falls outside the time range that is set for for PUMP
TIMER 2.
Current time: 10:00 PM (22:00)
Set temperature of output water: 120 °F
PUMP TIMER 1: OFF
PUMP TIMER 2: SET
5.
The display shows that PUMP TIMER 1 and PUMP TIMER 2 are
set, and one of them is in operation. In this example, PUMP
TIMER 1 is running because it is set to activate between 6:00 AM
and 9:00 AM. (See above.)Current time: 7:00 AM (7:00)
Set temperature of output water: 120 °F
PUMP TIMER 1: SET
PUMP TIMER 2: SET
6.
The display shows that PUMP TIMER 1 and PUMP TIMER 2 are
set, and none of them is in operation.
The current time falls outside the time ranges that are set for for
PUMP TIMER 1 and PUMP TIMER 2.
Current time: 10:00 AM (10:00)
Set temperature of output water: 120 °F
PUMP TIMER 1: SET
PUMP TIMER 2: SET
-Display example-
Normal Operaon
Owner's Guide
The display on the controller indicates which PUMP TIMER is set by displaying a number below the time:
1, 2, or 12. (12 indicates PUMP TIMER 1 and PUMP TIMER 2.)
The arrow to the right of ON or OFF indicates the current status of the PUMP TIMER(s). If the current
time falls within the time range set for a PUMP TIMER, the arrow will point toward ON. (The timer is ON.)
If the current time falls outside the time range set for a PUMP TIMER, the arrow will point toward OFF.
(The timer is OFF.)
See below for examples of each scenario. In each scenario below, PUMP TIMER 1 is set to activate at
6:00 AM (6:00) and deactivate at 9:00 AM (9:00). PUMP TIMER 2 is set to activate at 6:00 PM (18:00) and
deactivate at 9:00 PM (21:00).
To Next Page
Loading...
Need help?
General
