EasyManuals Logo

Takagi 540P Indoor User Manual

Takagi 540P Indoor
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
64 Page
TROUBLESHOOTING
GENERAL
PROBLEM SOLUTIONS
TEMPERATURE and AMOUNT OF HOT WATER
It takes a long time to
get hot water at the
fixtures.
 Check to see if a recirculation timer is active. If not, it will take time for
the hot water to get from the heater to the fixture.
 Check the recirculation pump for proper flow.
 The inlet filters on the return and inlet connections may need to be
cleaned.
The water is not hot
enough.
 Compare the flow and temperature. See the charts on p. 76.
 Check cross plumbing between cold water lines and hot water lines.
 Is the gas supply valve open fully? (p. 44)
 Is the gas line sized properly? (p. 31)
 Is the gas supply pressure sufficient? (pp. 31 and 62)
 Is the set temperature set too low? (pp. 51 and 60)
The water is too hot.  Is the set temperature set too high? (pp. 51 and 60)
The hot water is not
available when a
fixture is opened.
 Make sure the unit has 120 VAC, 60 Hz power supply.
 If you are using the remote controller and/or temperature controller, is
the power button turned on?
 Is the gas supply valve open fully? (p. 44)
 Is the water supply valve open fully? (p. 44)
 Is the filter on the cold water inlet and return connection clean? (p. 63)
 Is the hot water fixture sufficiently open to draw at least 0.5 GPM
(1.9 L/min) through the water heater? (p. 50)
 Is the unit frozen? (p. 61)
 Is there enough gas in the tank / cylinder? (For Propane model)
The hot water turns
cold and stays cold.
 Is the flow rate enough to keep the water heater running? (p. 50)
 If there is a recirculation system installed, does the recirculation line have
enough check valves? (p. 33)
 Is the gas supply valve open fully? (p. 44)
 Is the filter on the cold water inlet and return connection clean? (p. 63)
 Are the fixtures clean of debris and obstructions?
 Check if the flow rate is too low. (p. 50)
Fluctuation in hot
water temperature.
 Is the filter on the cold water inlet and return connection clean? (p. 63)
 Is the gas line sized properly? (p. 31)
 Is the supply gas pressure sufficient? (pp. 31 and 62)
 Check for cross connection between cold water lines and hot water lines.
Troubleshoong
Owner's Guide

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Takagi 540P Indoor and is the answer not in the manual?

Takagi 540P Indoor Specifications

General IconGeneral
BrandTakagi
Model540P Indoor
CategoryWater Heater
LanguageEnglish

Related product manuals