Hot Water Output Temperature Setting:
With the MOBIUS Water Heater output hot water temperature can be adjusted either with the optional
remote controller (Part TM-RE10, from 95 °F to 176 °F) or manually from the main computer control
boards dipswitch. Dipswitches can set four hot water output temperatures 113 °F, 140 °F, 167 °F,
and 176 °F. (Factory set temperature; 140 °F)
Manifold Multi-System Application for Large Volume.
MOBIUS Water Heater has full capability of manifolding multi-systems, with Multi-System Computer
Control (Optional Part TM-RE20). This Multi-System Computer Controller, you can manifold from 2
units to 20 units for commercial and residential application with each computer controller.
One computer (Part TM-RE20) system can make from 26,000 BTU to 4.7 Million BTU system, with
fully automatic modulation for large application
Electric Wiring: MOBIUS Water Heater Model T-M1 Electrical Load: Maximum 0.8 A, 120V per Unit.
Individual cut off switch, even though units have very low electrical load, recommended for multi-
system for the purpose of maintenance.
To Next Page
Loading...
Need help?
General
