Be sure to lock the safety lock
lever before leaving the operator’s
seat
Before leaving the operator’s seat, set
the safety lock lever securely to the
lock position and stop the engine. If any
controls should be touched accidentally
when the safety lock lever has not be
locked, the machine will move suddenly,
and cause serious injury or death.
Note that the dozer blade control is not
locked, even when the safety lock lever is
set to the lock position. Do not touch this
control accidentally.
Immediately after stopping the engine,
move all the control levers and pedals
several times in all directions to release
the pressure from the working equipment
circuitry.
Refer to the section titled “Releasing the
residual pressure” for further instructions.
Before leaving the operator’s seat, lower
the working equipment, lock the safety
lock lever, blade lever and boom swing
pedal and stop the engine. Also, be sure
to remove the key and take it with you.
General Precautions
Avoid fire and explosion hazards
Keep flames away from fuel, hydraulic fluid,
oil, grease and antifreeze. Fuel is particularly
flammable and dangerous.
When handling these combustible
materials, keep lit cigarettes, matches,
lighters and other flames or sources of
flames away.
Do not smoke or permit open flames while
fueling or near fueling operations.
Never remove the fuel cap or refuel with the
engine running or hot. Never allow fuel to
spill on hot machine components.
Clean up spilled fuel, oil or other flammable
fluids immediately.
Check for fuel, oil or hydraulic fluid leaks.
Stop all leaks and clean the machine before
operating.
Do not cut or weld on pipes or tubes that
contain flammable fluids. Clean thoroughly
with nonflammable solvent before cutting
or welding.
Remove all trash or debris from the
machine. Make sure that oily rags or other
flammable material are not stored on the
machine.
Handle all solvents and dry chemicals
according to procedures identified on
manufacturers’ containers. Work in a well-
ventilated area.
Never use fuel for cleaning purposes.
Always use a nonflammable solvent.
Store all flammable fluids and materials in
a safe and well-ventilated place.
To Next Page
Loading...
Need help?
General
