133
MAINTENANCE
Every 400 Hours
Inspecting the Transmission Gear
Oil
WARNING
� Stop the engine and allow the machine
to cool down before performing
maintenance.
• The transmission are hot directly after
the engine is stopped. Touching them
will cause burns.
• The gear oil is also hot and under high
pressure.
Be careful when loosening plugs.
Working on the machine under these
conditions could result in burns or
injuries.
� The pressure in the transmission
reduction gears case may cause oil
or the plug to fly out. Loosen the plug
slowly to release the pressure.
1. Park the machine on a level surface. Stop
the engine.
2. Remove the plug (1) from the transmission
housing.
3. If oil can be reached with the tip of the
your finger through the hole, the oil level
is correct.
4. If the level is low, add oil through the check
plug hole until the oil flows from the hole.
5. Install and tighten the plug.
Inspecting the Differential Gear
Oil
WARNING
� Stop the engine and allow the machine
to cool down before performing
maintenance.
• The differential are hot directly after
the engine is stopped. Touching them
will cause burns.
• The gear oil is also hot and under high
pressure.
Be careful when loosening plugs.
Working on the machine under these
conditions could result in burns or
injuries.
�
The pressure in the differential gears
case may cause oil or the plug to fly
out. Loosen the plug slowly to release
the pressure.
1. Park the machine on a level surface. Stop
the engine.
2. Remove the plug (1) from the differential
housing.
3. If oil can be reached with the tip of the
your finger through the hole, the oil level
is correct.
4. If the level is low, add oil through the add
plug hole (2) until the oil flows from the
hole.
5. Install and tighten the plug.
W2G017
OIL
Oil level
Ölstand
2
1
To Next Page
Loading...
