Use caution when fueling
� Do not smoke or permit open flames while
fueling or near fueling operations.
�
Never remove the fuel cap or refuel with the
engine running or hot. Never allow fuel to
spill on hot machine components.
�
Maintain control of the fuel filler nozzle
when filling the tank.
�
Do not fill the fuel tank to capacity. Allow
room for expansion.
�
Clean up spilled fuel immediately.
�
Tighten the fuel tank cap securely. Should
the fuel cap be lost, replace it only with
the original manufacturer’s approved cap.
Use of a non-approved cap without proper
venting may result in pressurization of the
tank.
�
Never use fuel for cleaning purposes.
�
Use the correct fuel grade for the operating
season.
Handling of hoses
Fuel, oil or hydraulic fluid leaks can cause
a fire.
�
Do not twist, bend or hit the hoses.
�
Never use twisted, bent or cracked hoses,
tubes and pipes. They may burst.
�
Retighten loose connections.
Be careful with hot and
pressurized components
Stop the engine and allow the machine to
cool down before performing inspection and
maintenance.
�
The engine, muffler, radiator, hydraulic
lines, sliding parts and many other parts
of the machine are hot directly after the
engine is stopped. Touching these parts
will cause burns.
�
The engine coolant, oil and hydraulic fluid
are also hot and under high pressure.
Be careful when loosening caps and plugs.
Working on the machine under these
conditions could result in burns or injuries
due to the hot oil spurting out.
Be careful with hot cooling
systems
Do not remove the radiator cap or drain plugs
when the coolant is hot. Stop the engine, let
the engine and radiator cool and loosen the
radiator cap or drain plugs slowly.
Maintenance Precautions
To Next Page
Loading...
Need help?
General
