5-6
MAINTENANCE
SERVICE DATA
* : If the ratio of traveling time to total operating time is high, replace the gear oil earlier than
the specified time.
** : For water, use tap water (soft). Do not use well or river water. When the ambient
temperature drops below 0°C (32°F), add coolant (antifreeze). Follow the coolant
manufacturer’s instructions to determine the mixture ratio.
*** : The hydraulic oil replacement interval depends on the type of hydraulic oil being used. New
machine are delivered with Takeuchi genuine hydraulic oil 46, and the hydraulic oil
replacement intervals indicated in this manual assume that Takeuchi genuine hydraulic oil
46 is being used. When using conventional antiwear hydraulic oil, the hydraulic oil should
be replaced every 2000 hours.
API standard: American Petroleum Institute
ACEA standard: Association des Constructeurs Européens d’Automobiles
SAE standard: Society of Automotive Engineers
Lubricant
SAE 10W-30
SAE 15W-40
ISO VG46
ISO VG32
ISO VG46
ISOVG68
Mixture of 50% coolant
Mixture of 30% coolant
Location Type
Type by air temperature
When to replace
-4 14 32 50 68 86 104°F
-20 -10 0 10 20 30 40°C
Engine oil pan
Diesel engine oil
API: CD class
ACEA: E-3, E-4 or E-5
Every 250 hrs.
Hydraulic oil
tank
Takeuchi genuine
hydraulic oil 46
Every 4000
hrs.***
Anti-wear hydraulic oil
Every 2000
hrs.***
Engine cooling
system
Cooling water (water +
coolant)**
SAE: J814C or J1034
Every 2000 hrs.
or every two
years (whichever
comes first)
Travel reduction
gear
Gear oil
API: GL-4
SAE 90
Every 1000 hrs
after the initial
250 hrs*.
Slew motor
pinion
Lithium based grease
EP-2
NLGI No.2
—
Every 50 hrs.
Slew bearing Every 50 hrs.
Working
equipment
Daily or every
10 hrs.
Levers When required
To Next Page
Loading...
Need help?
General
