5-44
MAINTENANCE
REPLACING THE TRAVEL MOTOR GEAR
OIL
Refer to “Replacing the travel motor gear oil”
on page 5-35.
EVERY 1000 HOURS
REPLACING THE AIR CLEANER ELEMENT
Stop the engine and allow the machine to
cool down before performing
maintenance.
• The engine, muffler, radiator and many
other parts of the machine are hot
immediately after the engine is stopped.
Touching these parts will cause burns.
IMPORTANT: Do not use an element if its
pleats, gaskets or seals are damaged.
IMPORTANT: Be sure to install the
element and dust cap securely. If not,
dust could be drain into the cylinder,
damaging the engine.
1. Open the engine hood.
2. Loosen the clamps (1) and remove the
dust cup (2).
3. Clean the inside of the dust cup (2).
4. Remove the primary element (3).
EVERY 1000 HOURS
REPLACING THE HYDRAULIC OIL
RETURN FILTER
Refer to “Replacing the hydraulic oil return
filter” on page 5-33.
To Next Page
Loading...
