Takeuchi TB225 User Manual

5-15
MAINTENANCE
MAINTENANCE LIST
Inspection and maintenance item Page
Every 500 hours
Replacing the fuel filter 5-42
Every 1000 hours
Replacing the hydraulic oil return filter 5-44
Replacing the travel motor gear oil* 5-44
Replacing the air cleaner element 5-44
Replacing the air breather 5-45
Inspecting and adjusting the engine valve clearance 5-46
Replacing the pilot line filter 5-46
Every 1500 hours
Inspecting and cleaning the engine fuel injectors 5-47
Inspecting the crankcase breather system 5-47
Every 2000 hours
Cleaning the engine cooling system 5-48
Lapping the engine valve seats 5-49
Every 4000 hours
Replacing the hydraulic oil and cleaning the suction strainer 5-50
When required
Replacing the bucket teeth and the side cutters 5-53
Replacing the bucket 5-56
Adjusting the gap between the bucket and arm (If equipped) 5-58
Lubricating the levers and pedals 5-60
Inspecting the rubber crawlers 5-61
Replacing the rubber crawlers 5-62
Inspecting and replenishing the windshield washer fluid 5-63
*: If the percentage of the traveling time within the total operating time is high, replace the gear
oil earlier than the specified time.

Takeuchi TB225 Specifications

General

Engine Make	Yanmar
Max Dig Depth	2, 580 mm
Bucket Capacity	0.03 - 0.11 m3
Max Reach	7, 010 mm
Max Digging Depth	3, 870 mm