Takeuchi TB225 User Manual

6-15
TROUBLESHOOTING
OTHER SYMPTOMS
Symptoms Major causes Remedies
Slewing is not possible or not
smooth
• Insufficient grease on slew
bearing
• Grease the bearing.
Refer to page 5-28.
Hydraulic oil temperature is
too high
• Hydraulic oil level too low • Add up to the specified
level.
Refer to page 5-21.
Starter motor turns but
engine does not start
• Insufficient fuel • Add fuel.
Refer to page 5-20.
• Air in fuel system • Bleed air.
Refer to page 6-9.
• Water in fuel system • Drain water.
Refer to page 5-29.
Crawlers come off • Crawlers too loose • Increase the tension.
Refer to page 5-26.
Engine exhaust is white or
bluish
• Excessive engine oil • Adjust to the specified level.
Refer to page 5-19.
• Poor fuel • Replace the fuel.
Engine exhaust is
occasionally black
• Air cleaner is clogged • Clean the air cleaner.
Refer to page 5-38.
Irregular noise is produced
from the engine
(combustion or mechanical
noise)
• Low quality fuel is being
used
• Replace the fuel.
• Engine is overheating • Refer to “If the engine
overheats” on page 6-3.
• Damage inside the muffler • Replace the muffler.
For replacement, ask your
sales or service dealer.

Takeuchi TB225 Specifications

General

Engine Make	Yanmar
Max Dig Depth	2, 580 mm
Bucket Capacity	0.03 - 0.11 m3
Max Reach	7, 010 mm
Max Digging Depth	3, 870 mm