143
TROUBLESHOOTING
Disconnecting the jumper cables
Once the engine starts, disconnect the
jumper cables following the connection
procedure in reverse order.
1.Disconnect the clip of jumper cable (B)
from the problem vehicle’s engine block.
2.Disconnect the other clip of jumper cable
(B) from the rescue vehicle’s “–” terminal.
3.Disconnect the clip of jumper cable (R)
from the rescue vehicle’s “+” terminal.
4.Disconnect the other clip of jumper cable
(R) from the problem vehicle’s “+” terminal.
Recharging
Have a Takeuchi sales or service outlet
recharge batteries that have gone dead.
TROUBLESHOOTING
If the Battery Goes Dead After the Fuel Runs Out
E4J006
R
B
4
1
3
2
Bleeding the Air from the Fuel System
1.Add fuel.
2.Turn the starter key to the ON position and
hold it there for about 20 seconds.
The automatic air bleeder bleeds the air
from the fuel system.
PREHEAT
OFF
ON
START
E4D002
Rescue vehicle battery Problem vehicle battery
From engine block
To Next Page
Loading...
Need help?
General
