84
OPERATION
Parking the Machine
Inspection and Checks After
Stopping the Engine
1.Check for oil and water leakage and
inspect the working equipment, covers and
lower body. If any irregularities are found,
repair.
2.Fill the fuel tank.
Refer to page 107 “Inspecting the Fuel
Level”.
3.Remove any paper scraps or dirt from the
engine room.
4.Remove any mud from the lower body.
Locking
Be sure to lock the following places:
¡Cab door
¡Fuel filler cap
¡Engine hood
¡Manual storage
Parking
¡Park the machine on firm, level ground
and apply the parking device. If you
must park on a slope or incline, block
the machine securely to prevent
movement.
¡Before leaving the operator's seat, set
the safety lock lever securely to the
lock position and stop the engine. If any
controls should be touched
accidentally when the safety lock lever
has not be locked, the machine will
move suddenly, and cause severe
injury or death.
1.Set the left and right travel levers to the
neutral position.
2.Return the throttle lever and idle the engine
at low speed.
3.Lower the bucket and dozer blade to the
ground.
4.Set the safety lock lever to the lock
position.
5.Stop the engine and remove the key.
Refer to page 65 “Stopping the Engine”.
WARNING
Dig in
Stopper
To Next Page
Loading...
Need help?
General
