What to do if a warning lamp flashes on my Takeuchi Compact Excavator?
If a warning lamp flashes, it indicates a problem. This could be an engine issue (refer to the respective warning lamp), a fan belt or charger problem (check the fan belt for slack or breakage and adjust), an issue with the engine lubrication system (inspect the engine oil level), high coolant temperature (refer to “If the engine overheats”), or low fuel level (add fuel).
What to do if the battery goes dead on my Takeuchi TB216 Compact Excavator?
If the battery goes dead, you can start the engine using jumper cables and a booster battery on another vehicle. Alternatively, ask your sales or service dealer to recharge the dead battery.
What to do if the engine overheats in my Takeuchi Compact Excavator?
If the engine overheats, immediately stop it and contact your sales or service dealer for repair. Alternatively, run the engine at low idle to cool the water temperature. Other steps include adjusting the fan belt slack, adding coolant, repairing water leaks, cleaning radiator fins, and cleaning sediment from the cooling system. If the problem persists, contact your sales or service dealer for further assistance.
What to do if a fuse blows in my Takeuchi Compact Excavator?
If a fuse blows, begin by inspecting the fuses. Replace the blown fuse with a spare fuse of the same capacity. If fuses continue to blow, the electric system is likely faulty, and you should contact your sales or service dealer for advice.
Why is my Takeuchi Compact Excavator not restarting after adding fuel?
If you're having trouble restarting after adding fuel, add fuel, open the valve of the water separator and the fuel filter. Then, turn the starter key to the ON position and hold it for about 60 seconds.
What to do if the cab or canopy is damaged on my Takeuchi TB216 Compact Excavator?
If the cab or canopy is damaged, immediately replace it. Do not operate the machine until the replacement is complete, and do not attempt to repair the damaged cab or canopy by welding.
Outlines general safety rules, operator responsibilities, and machine operation guidelines.
Provides safety guidelines for machine operation, visibility, and work area safety.
Explains the function and operation of safety lock, throttle, operating levers, and pedals.
Provides a step-by-step guide for safely starting and stopping the engine.
Details lever patterns, basic machine movements, and controls operation.
Lists prohibited operations and critical cautions for safe machine use.
Provides a schedule for routine inspections and maintenance tasks.
Details essential daily checks for coolant, oil, fuel, and water separator.
General| Engine Make | Yanmar |
|---|---|
| Engine Model | 3TNV70 |
| Transport Width | 980 mm |
| Bucket Capacity | 0.04 m³ |
| Maximum Reach | 4, 040 mm |
| Max Reach at Ground Level | 3, 980 mm |
To Next Page
